This page has all the information you need to get up and running with a 4.3" LCD on the Topaz Development Kit.  

 The 4.3” LCD module ships with:  

•  Interface cable (used to connect the module to the Topaz Development Kit)  
•  Mounting Kit (screws and spacers in a small plastic bag) 

 The 4.3" LCD module uses a URT 4.3" TFT LCD (model UMSH-8253MD-T) which includes a touch-screen. The resolution is 480x272.
The Topaz LCD modules includes an ID chip, so the Operating System knows which display driver to use.  

 You have a couple of options for setting up your 4.3" LCD with the Topaz Dev Kit.  

1. Side-by-side This is best if you need to attach things to the Topaz expansion headers

2. Mounted Mount the LCD board to the Topaz Dev Kit using that attached screws and spacers.

 Connecting the LCD Module to the Topaz Development Kit 

 For both options, you need to connect the LCD board and the dev kit together.
Follow these steps 

On the bottom of the Topaz Dev Kit you will find the LCD connector.  Open this and place the cable with the black side facing up.

Insert the cable into the connector.

Close the connector.

 Now connect the other end of the cable to the LCD module:  

Place the LCD face-down and line-up the cable and connector J1.

Insert the cable into the connector.

Close the connector.

 Turn both boards over, and you are ready to power up and test the connection.   

   

   

   

   

   

   

   

   

   

   

 The touch-screen calibration is usually close enough to enable you to operate a new board straight away. 

 If it is not accurate, recalibrate in Windows CE by selecting Start->Settings->Control Panel.  Double-tap the Stylus icon and select the calibration tab.  Press the Recalibrate button and follow the on-screen instructions.   

 If you need the side-by-side configuration, then there is nothing more to do! 

   

 Mounting the Topaz Development Kit and 4.3” LCD Board 

 The LCD kit box includes a small bag with 4 screws, 4 large spacers and 4 small spacers. 

   

 Follow these steps to mount the LCD board on the Development Kit: 

Turn the LCD and development kit over and place the small spacers over the mounting holes.

Flip the Topaz board over and position it above the LCD board.  Insert a screw into a large spacer and insert this into once of the mounting holes.

Add the remaining screws and spacers to complete the mounting.  Turn the board over and power on to verify that everything is running OK.